Replacing The Thread Lifters; Cleaning And Care - Miele HS10 Operating Instructions Manual

When changing the filter, please note
1. If you wish to replace exhaust filter a
with filter b, c or d, it is essential that
you remove the filter grille before you
fit the new exhaust filter.
If you are using exhaust filter c or d,
you must also activate the timestrip®
filter change indicator (Fig. 12).
2. If you wish to replace exhaust filter b,
c or d with filter a it is essential that
filter a is fitted in the filter grille* (Fig.
34).
* Filter grille – see "Optional ac-
cessories"

Replacing the thread lifters

(Fig. 37 + 38)
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lever the thread lifters from the slots.
To do so use a suitable tool, e.g. a flat
blade screwdriver.
 Fit new thread lifters.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.

Cleaning and care


Risk of electric shock from mains
voltage.
The mains voltage is applied to the
appliance even if it is switched off.
Before cleaning, switch the appli-
ance off at the wall socket and un-
plug it.
Vacuum cleaner and accessories

Risk of electric shock from mains
voltage.
If moisture gets into the vacuum
cleaner, there is a risk of electric
shock.
Do not let the vacuum cleaner get
wet.
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.

Damage due to unsuitable clean-
ing agents.
All surfaces are susceptible to
scratching. Contact with unsuitable
cleaning agents can alter or discol-
our the external surfaces.
Do not use abrasive cleaning agents,
glass cleaning agents, all-purpose
cleaners or oil-based conditioning
agents.
Dust compartment
The dust compartment can, if neces-
sary, be cleaned using a dry duster,
brush or, if available, a second vacuum
cleaner to vacuum the dust out.
en
45