Miele HS10 Operating Instructions Manual page 38

en
Connecting the suction hose to the
handle (Fig. 03)
 Fit the connector at the other end of
the suction hose into the handle until
it clicks into position.
Your vacuum cleaner is fitted with one
of the following suction tubes, depend-
ing on model:
- EasyLock suction tube
- Telescopic suction tube
- Comfort telescopic suction tube
Assembling the EasyLock suction
tube (Fig. 04)
 Hold the suction tube by the connec-
tion piece and push it into the second
suction tube, turning it clockwise or
anti-clockwise until it clicks into posi-
tion.
 Slide the connection piece upwards
until it clicks into position.
Connecting the handle to the suction
tube (Fig. 05 + 06)
 Insert the handle into the suction
tube until it clicks into position. To do
this, line up the guides on the two
pieces.
 To detach the handle from the suc-
tion tube, press the release catch
and pull the handle out of the suction
tube, twisting it slightly as you do so.
Adjusting the telescopic suction tube
(Fig. 07)
One part of the telescopic suction tube
is packed inside the other, and it can be
adjusted to suit your height for comfort-
able vacuuming.
38
 Grasp the release mechanism and
adjust the telescopic suction tube to
the required length.
Connecting the suction tube to the
adjustable floorhead (Fig. 08)
 Push the suction tube into the floor-
head and turn it clockwise or anti-
clockwise until it clicks into position.
 To separate the suction tube from the
floorhead press the release button
and pull the suction tube away from
the floorhead, twisting it slightly as
you do so.
Activating the timestrip® filter
change indicator on the exhaust filter
Depending on the model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (Fig.
09):
a AirClean
b AirClean Plus 50 (light blue)
c Active AirClean 50 (black)
d HEPA AirClean 50 (white)
If your vacuum cleaner is fitted with ex-
haust filter c or d, you need to activate
the timestrip® filter change indicator.
 Press the release catch for the dust
compartment lid and raise the lid as
far as it will go (Fig. 10).
 Remove the indicator strip (Fig. 11).
 Press the timestrip® filter change in-
dicator (Fig. 12).
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (Fig. 13).