Fig:using Dvm For Alignment - Motorola PTP 300 series User Manual

is proportional to the receive signal strength. To use remove the protective cap frome the case
mounted BNC connector and connect a DVM.Yo may have to invert the pole for correct reading.
Figure 24 shows the relationship between measured values and the receive signal strength.
When the alignment process is complete the installer MUST REMEMBER TO DISARM
UNITS in the link as described in
Turn off the audible alignment aid
Enable Adaptive Modulation
Fully enable Advanced Spectrum Management with i-DFS
Clear unwanted installation information from the various systems statistics
Store the link range for fast link acquisition on link drop
Enable higher data rates
6
After 24 hours, the units will be disarmed automatically provided that they are armed and that the link is UP.
Installation
Figure 24 fig:Using DVM For Alignment
Section 8.3.4
(Section 8.3.4.4
58
"Install Pages". This is necessary in order to:
"Disarm")
6
BOTH