Erase Configuration; Reboot Confirmation Pop Up; Confirm Erase Configuration Pop Up; Erase Configuration Successful Page - Motorola PTP 300 series User Manual

Recovery Mode
Figure 85 Reboot Confirmation Pop Up
The unit will now reboot. The unit should now start up in normal mode but with the IP address
set to 169.254.1.1 and the Ethernet interface set to auto-negotiate and auto-MDI/MDIX.
Should the unit fail to start up the user should refer to Section 10 "Fault Finding".
9.3 Erase Configuration
To erase the unit's configuration the user should press the "Erase Configuration" button on the
"Recovery Options" page (Figure 79). The user will now be presented with a pop up box asking
86).
them to confirm the action (Figure
Figure 86 Confirm Erase Configuration Pop Up
On confirmation the following page will be displayed (Figure 87). The user should now reboot
the unit by pressing the "Reboot" button.
Figure 87 Erase Configuration Successful Page
The user will now be presented with a pop up box asking them to confirm the action Figure 88.
122