Reset Ip And Ethernet Configuration; Software Download Complete Page; Reboot Confirmation Pop Up - Motorola PTP 300 series User Manual

When the download is complete a page is displayed indicating the status of the software download
81).
(Figure
After carefully checking that correct image has been downloaded the user should reboot the unit
by pressing the "Reboot Wireless Unit" button. The user will then be presented with a pop up
box asking them to confirm the action
The unit will now reboot. Providing the unit configuration is still intact the unit should restart in
normal operational mode and the link should recover. Should the unit or link fail to recover the
user should refer to
9.2 Reset IP and Ethernet Configuration
To reset IP and Ethernet configuration back to factory defaults the user should press the "Reset
IP and Ethernet Configuration back to factory defaults" button on the "Recovery Options" page
79). The user will now be presented with a pop up box asking them to confirm the action
(Figure
83).
(Figure
On confirmation the following page will be displayed
the unit by pressing the "Reboot" button.
Recovery Mode
Figure 81 Software Download Complete Page
(Figure
Figure 82 Reboot Confirmation Pop Up
Section 10 "Fault Finding".
82)
(Figure 82). The user should now reboot
120