Hydraulic Control Manifold Service: Cutting Deck Lift/Lower - Toro Groundsmaster 4100-D Service Manual

Hydraulic Control Manifold Service: Cutting Deck Lift/Lower

35 to 40 ft- -lb
(47 to 54 N- -m)
3
41 to 49 in- -lb
(4.6 to 5.6 N- -m)
6
7
1
1. Manifold body
2. Pilot valve
3. Seal kit
NOTE: The ports on the manifold are marked for easy
identification of components. Example: C1 is the con-
nection port from the LH wing deck lift cylinder and CHG
is the charge circuit connection (See Hydraulic Sche-
matic to identify the function of the hydraulic lines and
cartridge valves at each port).
For cartridge valve service procedures, see Hydraulic
Control Manifold Service: 4 Wheel Drive in this section.
Refer to Figure 59 for cartridge valve and plug installa-
tion torque.
Groundsmaster 4100--D
2
5
Figure 59
4. Relief valve (Counterbalance)
5. Seal kit
Page 4 - - 75
35 to 40 ft- -lb
4
(47 to 54 N- -m)
35 to 40 ft- -lb
2
(47 to 54 N- -m)
3
6. Plug (SAE #2)
7. O- -ring
Hydraulic System