Table of Contents
Advertisement
4
Maintenance > Related Error Code > #853
#853
Some jobs entered by the iR host machine may be cancelled even if the printing instruction is
given to the iR host machine from the PC.
If you check the error code in the following operations, you can obtain the reference
information which can specify the cause.
Press 'System state/Stop' button on the lower right of the control panel to display the job
history.
Select a job that resulted in NG, press 'Further information' button, then the error code is
displayed in the space of Result.
The error code "#853" (An error or non-support function is detected in the host machine and
the job is canceled) has 30 or more causes. It has been difficult to specify the cause, as 30
or more causes are lumped together as #853.
The details of the cause of Job cancel are shown in the list below.
First, codes: #xxx shown in the attachment list, are allocated to the causes that are lumped
together as #853 in Job history on the UI screen.
Select FUNCTION > MISC-P > PJH-P-1/2, then detailed codes in the list below are displayed
4
Maintenance > Related Error Code > #853
.
State
Cause
#853 32 Job cancel due to spool
When 'Spool' is set to 'ON',
over of CPCA Send data
the data received from the
(Job type: Print job, PC-
Host cannot be spooled
FAX job)
completely because the
spool area (HDD) of the
received data is full.
2
The number of Binder
The number of Binder
and Document of CPCA
and Document exceeds
exceeds the upper limit
the upper limit during the
(Total 400/each in whole
processing of received
device)
data.
38 The number of secure jobs
The number of entered
exceeds the upper limit.
secure jobs exceeds the
(Even though the number of
limit of jobs receivable at a
normal PDL print exceeds
time.
the upper limit, the job
itself is not recorded in the
history, as the job is not
created at that point. In
secure job, exceeding the
upper limit may occur, as
the job is kept until printing
is completed.)
A detailed history report is output so that users can check the internal (CPCA job log) detailed
cause in service mode, since detailed causes are grouped to some extent on the UI display.
But, this report shows only PDL print job.
FUNCTION > MISC-P > PJH-P-1 (Latest 100 jobs)
FUNCTION > MISC-P > PJH-P-2 (Max. 5,000 jobs)
4-3
Remedy
Use Spool function under
System Control Setup >
Network Setup in service
mode.
Re-send the data after the
Spool function is set to 'OFF'.
Try to print again after all jobs
are finished. If the print job
cannot be done, check the
sent data.
Execute the secure jobs
accumulated in the host
machine or delete them, and
then try to execute again.
T-4-1
4-3
Advertisement
Table of Contents
