Bosch GTA3800 Operating/Safety Instructions Manual page 9

BM 2610013406 06-10:BM 2610013406 06-10 6/14/10 9:52 AM Page 9
TRANSpoRTING STAND WITH SAW
1. Unlock tool mounts and slide saw along table
top surface until it is against the Transport
Stop (see page 8).
Note: For most comfortable transport, saw
should be positioned at the end of the stand
closest to the Transport Wheels. Adjust
Transport Stop, if necessary.
2. Close and lock Extension Rails (see page
12).
Note: Sticker designating lift handle location
affixed to stand end cap. These are your lift
handles and should be used when lifting the
stand for the following procedures.
All manuals and user guides at all-guides.com
3. Fold stand legs: Begin at end with installed
4. Repeat same step on opposite side, folding
5. To transport, grip the lift handle and roll to
6. To setup stand for use, follow same
FIG. G
-9-
Transport Wheels. First, lift stand at
designated lift handle. Push in a leg locking
pin and rotate that leg up until the locking pin
clicks into place. (See page 6) Repeat for
second leg and lower stand down onto
wheels.
legs into place.
location on Transport Wheels.
instructions above, starting with either side of
stand desired.
FIG. H