Bosch GTA3800 Operating/Safety Instructions Manual page 8

BM 2610013406 06-10:BM 2610013406 06-10 6/14/10 9:52 AM Page 8
ASSEMBLING TRANSpoRT WHEELS
The Transport Wheels allow the user to
relocate the stand without moving the saw.
The wheels can be attached to either the right
or left side of the stand.
1. Lay the stand upside down on the floor with
folded legs facing upward.
2. Line up the Transport Wheel Assembly with
the hole pattern either on the right or left
side of the stand.
3. Utilize the included Multi-purpose tool and
insert the M6 x 12mm Allen head screw
through the wall and attach the M6 Nylok
Nut. Repeat with three (3) remaining and
tighten.
4. Roll the stand over so it is lying on its
wheels and the stand should roll across the
ground smoothly when using the opposite
end as a handle.
All manuals and user guides at all-guides.com
FIG. E
-8-
TRANSpoRT STop
1. The GTA3800 includes a Transport Stop to
help prevent the saw from sliding off the
stand in the event it is not secured to the
table prior to transport.
2. Loosen the locking knob on the side of the
saw stand on which the transport wheels
are fastened and pull the table extension
out about 4-inches (102 mm).
3. Insert the transport stop into the groove in
the table top surface and slide it so it is
completely within the main table; beyond
the blue end cap.
4. Use the Multi-purpose tool to firmly tighten
the hex bolt in the stop so it does not move
and will help prevent the tool from slipping
down during transport.
FIG. F