Bosch GTA3800 Operating/Safety Instructions Manual page 11

BM 2610013406 06-10:BM 2610013406 06-10 6/14/10 9:52 AM Page 11
3. Place miter saw on top of the tool mounts,
Figure M. Align mounting holes by
adjusting rear sliding nuts and front swivel
nuts. Be sure the front of the saw is
aligned to the front of both tool mounts.
4. Place one (1) M6 flat washer onto one (1)
8 mm x 45 mm bolt, and insert through
RE R
SLIDING NUT
FRONT
SWIVEL NUT
REMovE SAW FRoM STAND (WITH TooL
MoUNTS ATTACHED)
1. Press unlock button on each tool mount
and open the release lever to the
unlocked position. (See Page 10)
2. Locate the carry handles at the base of
the saw. Place one hand on the saw base
handle and the second on the saw's top
handle, if available, or the other base
handle. Holding tightly, tilt the saw (with
the tool mounts still attached) toward
yourself and lift it from the stand.
ATTACH THE SAW To THE STAND (WITH
TooL MoUNTS ATTACHED)
1. Make sure the tool mount release levers
on each mount are in the open and
unlocked position. (See Page 10)
2. Locate the carry handles at the base of
the saw. Place one hand on the saw base
All manuals and user guides at all-guides.com
5. Repeat step 4 of this procedure for the
6. Securely tighten all four (4) bolts.
FIG. M
3. Position the tool mounts anywhere along
4. Tilt the saw until the front jaws of both tool
5. Push the release lever on each tool
position before operating or transporting the
saw.
-11-
miter saw base and loosely tighten into
tool mounts.
remaining three (3) hole locations.
handle and the second on the saw's top
handle, if available. Lift the saw to the rail
assembly.
the length of the rail assembly.
mounts are engaged on the rail. With both
hands on the saw handles, guide the saw
back to its level position on the rail (See
Page 10).
mount to the "locked position".
Be sure the tool mount
W RNING
levers are in the locked