Connect Signal And Power Cables; To Reduce Vibrations Of Wallmounted Unit - Beko BEHPI 090 Installation Manual

6 Outdoor un t nstallat on
2. Pre-dr ll holes for expans on bolts.
3. Clean concrete dust away from holes.
4. Place a nut on the end of each expans on bolt.
5. Hammer expans on bolts nto the pre-dr lled holes.
6. Remove the nuts from expans on bolts, and place outdoor un t on bolts.
7. Put washer on each expans on bolt, then replace the nuts.
8. Us ng a wrench, t ghten each nut unt l snug.
Warn ng
A
When dr ll ng nto concrete, eye protect on s recommended
at all t mes.
If you w ll nstall the un t on a wall-mounted bracket , do the follow ng:
Warn ng
Before nstall ng a wall-mounted un t, make sure that the
A
wall s made of sol d br ck, concrete, or of s m larly strong
mater al. The wall must be able to support at least four
t mes the we ght of the un t.
1. Mark the pos t on of bracket holes based on d mens ons n the Un t Mount ng D mens ons chart.
2. Pre-dr ll the holes for the expans on bolts.
3. Clean dust and debr s away from holes.
4. Place a washer and nut on the end of each expans on bolt.
5. Thread expans on bolts through holes n mount ng brackets, put mount ng brackets n pos t on, and
hammer expans on bolts nto the wall.
6. Check that the mount ng brackets are level.
7. Carefully l ft un t and place ts mount ng feet on brackets.
8. Bolt the un t f rmly to the brackets.
To reduce v brat ons of wallmounted un t
If allowed, you can nstall the wall-mounted un t w th rubber gaskets to reduce v brat ons and no se.
Step 4: Connect s gnal and power cables
The outs de un t's term nal block s protected by an electr cal w r ng cover on the s de of the un t. A
comprehens ve w r ng d agram s pr nted on the ns de of the w r ng cover.
Spl t-type room a r cond t oner / Installat on Manual
33 / 120 EN