Level Front Roller To Reel - Toro Reelmaster 5200-D Service Manual

Level Front Roller to Reel

1. Adjust rear roller assembly to the lowest height-of-
cut (see Adjust Height-of-Cut). Do not tighten lock nuts
securing rear roller brackets at this time.
NOTE: Be sure the plate covers the full length of
reel blades.
2. Place a 1/4 inch (6.4 mm) or thicker plate under the
reel blades and against the cutting edge of the bedknife.
Rear roller should not contact surface.
NOTE: When securing the front roller brackets, tighten
fastener on inside of cutting unit frame so position of roll-
er bracket does not change.
3. Level front roller to reel by loosening both cap screws
holding each front roller bracket and rotating front roller
until it contacts surface that plate is on. Tighten cap
screws and make sure roller has not changed position.
To prevent moving the front roller bracket when tighten-
ing, hold nut and tighten cap screw.
NOTE: This adjustment should be made on a flat
working surface.
Reelmaster 5200-D/5400-D
3
2
1. Steel plate
2. Front roller bracket
3. Cap screws
Page 8 - 9
Rev. A
4
5
1
Figure 11
4. H.O.C. adj. bolt
5. Lock nut
6. Rear roller bracket
Cutting Units
(Model 03506, S/N 80001 - 209999999)
(Model 03509, S/N 80001 - 209999999)
6