Specifications; Special Tools - Toro Reelmaster 5200-D Service Manual

Specifications

Item
Front wheel lug nut torque
Front to rear housing torque
Transmission to axle torque
Differential bearing cap torque
Pinion coupler nut torque
Ring gear to differential case torque
Fill pipe torque
Side plate (gear cover) torque
Axle bearing retainer/seal plate (screw) torque
(Serial No. 80001 - 200000200)
Axle bearing cap (screw) torque
(Serial No. 200000201 & Up)
Ring gear to pinion gear backlash
Pinion gear end play

Special Tools

Order these tools from the TORO SPECIAL TOOLS AND APPLICATIONS GUIDE (COMMERCIAL PRODUCTS).
Differential Gear Holder
Remove gear cover from right hand side of differential
and bolt this tool in place to lock spur gear in position
when removing nut that secures pinion coupler for 4WD
drive shaft.
Differential Axle
0.003 to 0.007 in. (0.076 to 0.178 mm)
0.000 to 0.005 in. (0.000 to 0.127 mm)
Page 6 - 2
Rev. A
Specification
45 to 55 ft-lbs (61 to 75 Nm)
18 to 28 ft-lbs. (24 to 38 Nm)
25 to 30 ft-lbs. (34 to 41 Nm)
30 to 45 ft-lbs. (41 to 61 Nm)
75 to 90 ft-lbs. (100 to 122 Nm)
45 to 65 ft-lbs. (61 to 89 Nm)
20 to 30 ft-lbs. (27 to 41 Nm)
25 to 40 ft-lbs. (34 to 54 Nm)
16 to 20 ft-lbs. (22 to 27 Nm)
32 to 35 ft-lbs. (43 to 47 Nm)
Figure 3
Reelmaster 5200-D/5400-D