Make Connections In The Power Supply Box - Bosch AUTODOME IP starlight 7000i Installation Manual

52 en | Installing the Roof Parapet and Pipe Mounts
Caution!
You must tighten the two mounting screws to a minimum torque of 10-12 N-m (90‑105 in.-lbs)
!
to ensure a proper seal between the arm and the housing.
6.
7.
Caution!
Do not over tighten the bolts. The maximum torque is 34 N-m (25 ft-lb).
!
10.7

Make Connections in the Power Supply Box

1.
2.
3.
2021-03 | 1.2 |
Rotate the arm to swing the camera out from the roof and into position, if installing a
Parapet Roof Mount.
Tighten the three (3) 10-mm (3/8-inch) stainless steel hex bolts on the bracket to lock the
Parapet Arm in position.
Attach the earth ground wire to the grounding screw on the left side of the box.
Connect the 24 VAC to Dome plug, installed previously, to its mating connector P107 on
the right side of the box.
Connect the 115/230 VAC, 3-pin Power-in plug, installed previously, to its mating
connector P101 on the left side of the box.
Installation Manual
AUTODOME IP starlight 7000i
Bosch Security Systems