Attach Pendant To Pipe And Tighten - Bosch AUTODOME IP starlight 7000i Installation Manual

AUTODOME IP starlight 7000i
10.6

Attach Pendant to Pipe and Tighten

1.
2.
Figure 10.9: Pendant to Roof / Pipe Mount Attachment
1
2
2a Dome Cap
2b Recessed Hinge Pin
2c Dome Connector
3
4
3.
4.
Caution!
If you feel any resistance when rotating the dome housing or when engaging the connector,
!
stop immediately and start over.
5.
Bosch Security Systems
Before attaching the Pendant, visually inspect the Pendant dome and the Interface Board
connectors for any blocked pin holes and bent pins.
Tilt the Pendant enough to place its mounting hook on top of the its housing, over the
recessed hinge pin of the Dome Cap.
a
b
c
Tilt Dome
Hook and drop
Rotate down to engage dome connector
Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs)
Drop the Pendant down slightly to engage the dome hook and hinge pin of the Dome Cap,
allowing the dome to rotate around the hinge pin.
Rotate the dome housing down to a vertical position and gently push upward to engage
the connector on top of the dome housing.
Hold the housing firmly in position and alternately tighten the two (2) 5-mm Allen head
mounting screws from above to a torque value of 10-12 N-m (90-105 in.-lbs).
Installing the Roof Parapet and Pipe Mounts | en
Installation Manual
51
2021-03 | 1.2 |