Installing The Main Battery; Charging The Battery; Charging The Main Battery And Memory Backup Battery - Motorola FR6874 User Manual

FR6800 User Guide
Make a call to verify connection.
4.
For detailed information about WWAN activation and settings, refer to the FR6874 Integrator Guide.
NOTE

Installing the Main Battery

The FR6874 ships with a
NOTE
To install the main battery:
Insert the battery, top first, into the battery compartment in the back of the FR6874.
1.
NOTE Position the battery correctly, with the battery charging contacts on top of the charging contacts in the battery
compartment.
Press the battery down into the battery compartment until the battery release latch snaps into place.
2.
With the battery cover latches open, insert the cover, bottom first, then press down on the top of the cover.
3.
Close the battery cover latches on either side of the battery cover.
4.
The FR6874 powers up after inserting the battery and replacing the battery cover.

Charging the Battery

Ensure that you follow the guidelines for battery safety described in Battery Safety Guidelines on page 7-2.
CAUTION

Charging the Main Battery and Memory Backup Battery

Before using the FR6874 for the first time, charge the main battery until the amber Charging/Battery Status LED
remains lit (see Table 1-2 on page 1-7
with the appropriate power supply. For information about the accessories available for the FR6874, see
Accessories.
The FR6874 is equipped with a memory backup battery which automatically charges from the fully-charged main
battery. When using the FR6874 for the first time, the backup battery requires approximately 36 hours to fully
charge. This is also true any time the backup battery is discharged, which occurs when the main battery is removed
for several hours. The backup battery retains RAM data in memory for at least 15 minutes (at room temperature)
when the FR6874's main battery is removed. When the FR6874 reaches a very low battery state, the combination
of main battery and backup battery retains RAM data in memory for at least 48 hours.
To charge the main battery, use either a charging cable or a cradle. For cable and cradle setup and charging
procedures refer to the FR6874 Integrator Guide.
1950 mAh battery. An optional
Inserting the Battery
Figure 1-4/1-5
for charge status indications). To charge the FR6874, use a cable or a cradle
3600 mAh battery is available.
15
Getting Started
Chapter 6,