Notification Parameters - Panasonic KX-TVM50 Programming Manual

2.1.4

Notification Parameters

The VPS can notify subscribers when new messages have been recorded in their mailboxes. There
are 3 notification methods: lighting the Message Waiting Lamp on a PT, calling to another telephone,
and calling the subscriber's beeper (pager). 3 destinations (Device 1, 2, 3) can be specified per
mailbox, allowing a subscriber to receive notification by beeper (pager) during the day and by
telephone at night, for example.
Message Waiting Lamp
If set to "Enable", the Message Waiting Lamp of the subscriber's telephone turns on when a new
message is recorded.
Value Range
Disable, Enable
Feature Guide References
2.3.30 Message Waiting Notification—Lamp
Beeper (Pager) Callback No. Entry Mode
This feature allows a caller to dial his or her own telephone number which the VPS then sends to the
subscriber's beeper (pager).
Note
• To use this feature, the callback number entry code "X" must be programmed along with the
subscriber's beeper (pager) number. If the caller does not enter a callback number, or if this
feature is set to "Disable", the "System Callback No." (set in "System Parameters→
Parameters→Message Waiting Notification") will be displayed on the beeper's (pager's)
display instead. In either of these cases, if a caller's telephone number is received through
the telephone company's Caller ID service, the VPS will send the caller's number to the
beeper (pager) regardless instead of the "System Callback No.".
Value Range
Caller Select: After recording a message, the caller is asked whether or not he or she wishes to enter
a callback number.
Without: Without recording a message, the caller is asked to enter a callback number.
Before: Before recording a message, the VPS asks the caller to enter a callback number.
After: After recording a message, the VPS asks the caller to enter a callback number.
Disable: Disables the Callback Number Entry feature. Either the caller's telephone number received
by through the telephone company's Caller ID service or the "System Callback No." will be sent to the
beeper (pager).
Programming Guide References
"System Callback No." in 2.5.4 Parameters
2.1 Mailbox Settings
Programming Guide 41