NEC Express5800 Series Maintenance Manual page 138

Chapter 3 Appendix
Error Message
B301 Expansion ROM not
initialized – Mezzanine
Slot 1
B302 Expansion ROM not
initialized – Mezzanine
Slot 2
B303 Expansion ROM not initialized
– Mezzanine Slot 3
B304 Expansion ROM not initialized
– Mezzanine Slot 4
B30A Expansion ROM not initialized
– I/O Blade PCI Slot
B311 IOV-SW Module 1 Slot 1
B312 IOV-SW Module 1 Slot 2
B313
IOV-SW Module 1 Slot 3
B314 IOV-SW Module 1 Slot 4
B321 IOV-SW Module 2 Slot 1
B322 IOV-SW Module 2 Slot 2
B323 IOV-SW Module 2 Slot 3
B324
IOV-SW Module 2 Slot 4
B022 Serial Port Configuration
Overlapped.
B030
PCI System Error on
Bus/Device/Function
B040 PCI Parity Error on
Bus/Device/Function
C010 The error occurred during
temperature sensor reading
C011 System Temperature out of the
range.
C020 The error occurred during
voltage sensor reading.
C021 System Voltage out of the
range.
C040 SROM data read error
st
C061 1 SMBus device Error
detected.
nd
C062 2 SMBus device Error
detected.
rd
C063 3 SMBus device Error
detected.
th
C064 4 SMBus device Error
detected.
th
C065 5 SMBus device Error
detected.
138
Cause
Failed to expand option ROM of
Mezzanine slot 1.
Failed to expand option ROM of
Mezzanine slot 2.
Failed to expand option ROM of
Mezzanine slot 3.
Failed to expand option ROM of
Mezzanine slot 4.
Failed to expand option ROM of I/O
Blade PCI slot.
Failed to expand option ROM of
IOV-SW Module 1 slot 1.
Failed to expand option ROM of
IOV-SW Module 1 slot 2.
Failed to expand option ROM of
IOV-SW Module 1 slot 3.
Failed to expand option ROM of
IOV-SW Module 1 slot 4.
Failed to expand option ROM of
IOV-SW Module 2 slot 1.
Failed to expand option ROM of
IOV-SW Module 2 slot 2.
Failed to expand option ROM of
IOV-SW Module 2 slot 3.
Failed to expand option ROM of
IOV-SW Module 2 slot 4.
Overlapping serial port
configuration was detected.
PCI SERR was detected.
PCI PERR was detected.
An error occurred while reading the
temperature sensor.
A temperature abnormality was
detected.
An error occurred while reading the
voltage sensor.
A system voltage abnormality was
detected.
SROM data reading error
st
An error occurred in the 1 SM Bus.
nd
An error occurred in the 2 SM
Bus.
rd
An error occurred in the 3 SM
Bus.
th
An error occurred in the 4 SM
Bus.
th
An error occurred in the 5 SM
Bus.
Express5800/B120e-h Maintenance Guide
1. POST Error Message
Solution
Disable expansion of option ROM of the
board that is not used for OS boot.
Disable expansion of option ROM of the
board that is not used for OS boot.
Run SETUP, select Advanced → Serial
Port Configuration, and specify the setting
again in a way that the values of Base I/O
or Interrupt in Serial Port A and Serial Port
B will not be the same.
Contact your sales representative.
It is possible that a fan has failed or is
clogged. Contact your sales representative.
Contact your sales representative.
(5/7)