Configuring The Second Dap-3712 In Client Mode - D-Link DAP-3712 User Manual

Section 2 - Installation

Configuring the Second DAP-3712 in Client Mode

1. Follow steps 1-4 of the instructions above to power on
the device. Launch the Setup Wizard to configure the
device in Client Mode.
2. To avoid an IP address conflict, change the IPv4 address
so that it is different from the first DAP-3712's IP address
(for instance, by changing it to 192.168.0.51, as in the
following screenshot).
3. On step four of the Setup Wizard (Wireless), select Client
from the drop-down list. Enter the same SSID and key
that you entered when configuring the first device.
4. To confirm that wireless connectivity between the two
devices is configured correctly, navigate to the Status
page and check the information under Associated
Stations (shown below).
D-Link DAP-3712 User Manual 14