D-Link DAP-3712 User Manual page 22

Section 3 - Configuration
4. Wireless
Wireless Mode: There are four wireless modes: Access Point, Client,
Access Point (WDS), and Client (WDS). To use a
point-to-point or point-to-multipoint connection,
you need to configure the primary DAP-3712 in
Access Point or Access Point (WDS) mode and the
other DAP-3712s in Client mode or Client (WDS)
mode.
If you want to preserves MAC address of clients
frame , it is suggest to use Acess Point(WDS) and
Client (WDS) for each size.
SSID: You can set the SSID which the device will
broadcast when Access Point or Access Point
(WDS) is selected. Alternately, set the SSID of the
remote site when Client or Client (WDS) is selected.
The default SSID is dlink.
Channel Width: Use this to select the channel bandwidth of the
DAP-3712. The default is 80 Mhz.
Frequency Use this to select the Wi-Fi channel the AP will
(Channel): broadcast on. The available channels depend on
the county you selected.
Transmit Use this to set the DAP-3712's output power.
Power:
Encryption: You can select which Wi-Fi encryption the DAP-
3712 should use: Open, WPA-PSK, WPA2-PSK, WPA/
WPA2 Hybrid-PSK, or IEEE802.1X.
Key: To input the WiFI encryption key. The default key
is 1234567890abc
D-Link DAP-3712 User Manual 22