Bosch Rexroth IMenip2 Installation Instructions Manual page 19

3 608 870 F34/2017-05 | IMenip2
Device description
Transfer rates of 10 MBit/s or 100 MBit/s are
supported.
Fig. 1: IMenip2 interface module, front view
(socket)
1 NS LED (network status)
2 MS LED (module status)
3 Port 1: LINK LED (connection/activity)
4 Port 2: LINK LED (connection/activity)
Interface connection
The interface has an 8-pin RJ45 socket de-
sign.
Suitable connection plugs
Use connection plugs in accordance with
standard IEC 61158.
Display elements
The NS LED indicates the Ethernet status.
Tab.1: NS
LED display Meaning
Off No voltage or invalid IP address
Green Online, one or more connections
to master established (CIP class
1 or 3), ready for operation
Flashing Online, no connection to master
green established
Red Double IP address or blocking
error
Flashing red Time-out reached in one or more
connections (CIP class 1 or 3)
Bosch Rexroth AG
The MS LED indicates the interface module
status.
Tab.2: MS
LED display Meaning
Off No voltage
Green Module controlled by a scanner
during operation
Flashing Not configured or scanner in idle
green mode
Red Error (exception error or blocking
error)
Flashing red Self-acknowledged error. Used
configuration differs from stored
configuration
The LINK LED indicates the connection or
activity via Ethernet.
Tab.3: LINK
LED display Meaning
Off No connection, no activity
Green Connection (100 Mbits/s) estab-
lished
Flickering Activity (100 Mbits/s)
green
Yellow Connection (10 Mbits/s)
established
Flickering yel- Activity (10 Mbits/s)
low
19/28