Bosch Rexroth IMenip2 Installation Instructions Manual page 17

3 608 870 F34/2017-05 | IMenip2
Qualified personnel are those who can rec-
ognize possible hazards and institute the ap-
propriate safety measures due to their
professional training, knowledge, and experi-
ence as well as their understanding of the rel-
evant conditions pertaining to the work to be
done. Qualified personnel must observe the
rules relevant to the subject area.
Safety instructions in this document
In this manual, there are safety instructions
before the steps whenever there is a danger
of personal injury or damage to the equip-
ment. The measures described to avoid these
hazards must be observed.
Safety instructions are set out as follows:
SIGNAL WORD
Type of RISK!
Consequences
Precautions
• Safety sign (warning triangle): draws at-
tention to the risk
• Signal word: identifies the degree of haz-
ard
• Type of risk: identifies the type or source
of the hazard
• Consequences: describes what occurs
when the safety instructions are not com-
plied with
• Precautions: states how the hazard can
be avoided
Bosch Rexroth AG
This warning symbol cautions
against dangers to your health.
Observe all the safety instruc-
tions that follow this symbol to
avoid possible injuries or death.
This warning symbol cautions
against dangers to your health
caused by electrical voltage or
currents. Observe all the safety
instructions that follow this sym-
bol to avoid possible injuries or
death.
The signal words have the following meaning:
CAUTION
CAUTION indicates a potentially hazard-
ous situation which, if not avoided, could
result in minor or moderate injury or dam-
age to equipment.
Adhere to the following instructions
General safety instructions
Only accessories and add-on units that have
been approved for use in Rexroth tightening
systems may be used therein. Non-approved
components may neither be added nor con-
nected to the system. The same applies to
cables and lines which belong to the Rexroth
tightening system. Otherwise, functional and
system safety is jeopardized.
Observe the regulations for accident preven-
tion and environmental protection for the
country where the product is used and at the
workplace.
Exclusively use Rexroth products in good
technical order and condition.
Check the product for visible defects, for ex-
ample damage to the circuit board, compo-
nents, housing, and plug connectors or
missing screws.
17/28