Toro Sand Pro 3040 Service Manual page 69

Installing the Engine (continued)
Sand Pro ® 3040 and 5040
20251SL Rev A
9. Connect the machine wire harness at the left side of the engine:
• Violet wire at the engine magneto lead
• Fusible link at the voltage regulator
• Red wire at the engine fuel solenoid lead
10. Connect the fuel supply hose and the evaporative control system vent hose.
11. Connect the throttle control cable to the governor control plate and the choke
control cable to the choke lever; refer to
to ensure the choke and throttle linkage is able to move smoothly from fully
open to fully closed. Adjust the cables as necessary.
12. Position a new intake gasket on the engine. Install the intake elbow and
tighten the fasteners to 7 N·m (60 to 65 in-lbs).
Make sure that all air cleaner components and breather tube are
in good condition and are properly secured during assembly. Any
leaks in the air filter system will allow dirt into engine and will cause
serious engine damage.
13. Secure the breather tube to the intake elbow with the previously removed
hose clamp.
14. Secure the air intake tube to the intake elbow with the previously removed
hose clamp; refer to
15. Install the hitch assembly with the exhaust shield and muffler guard; refer to
Removing and Installing the Hitch Assembly (page
16. Install the battery; refer to
17. Ensure that all the wires, fuel lines, hydraulic hoses, and cables are clear of
moving parts and secured to their original locations.
18. Check the engine-oil level and adjust if necessary.
19. Start the engine and check for fuel leaks. Repair any leaks as required.
20. Install any previously removed rear attachments.
Figure
IMPORTANT
Installing the Air Cleaner Assembly (page
Removing and Installing the Battery (page
Page 4–19
16. Check the cable operation
4–9).
7–22).
6–31).
Engine: Service and Repairs