Testing the Hydraulic Solenoid Valve Coils (continued)
Electrical System: Testing the Electrical Components
D. Install the coil and the nut onto the valve and tighten nut to 7 N∙m (60
in-lb).
4. If the solenoid coil resistance is correct and a circuit problem still exists,
check the wire harness; refer to
5. After testing is completed, connect the wire harness connector to the
solenoid coil.
Appendix A (page
Page 6–24
A–1).
Sand Pro
®
3040 and 5040
20251SL Rev A