Toro Sand Pro 3040 Service Manual page 66

Removing the Engine (continued)
Engine: Service and Repairs
The engine and exhaust system may be hot. To avoid possible
burns, allow the engine and exhaust system to cool before removing
engine from machine.
4. Remove the hitch assembly from the rear of the machine; refer to
and Installing the Hitch Assembly (page
Note: The exhaust shield and muffler guard are attached to the hitch roller
plate, and are removed during hitch removal.
5. Remove the air cleaner hose from the machine; refer to
(page 4–9).
6. Disconnect the breather tube from the intake elbow.
7. Remove the four (4) flange head screws that secure the intake elbow to the
carburetor and remove the intake elbow and gasket. Discard the gasket.
Ensure that all of the gasket material is removed from the carburetor and
the intake elbow.
8. Disconnect the throttle control cable and choke control cable from the engine.
g355546
1. Throttle control cable clamp
9. Close the fuel shut-off valve. Clamp the fuel hose near the engine to prevent
fuel spillage, then disconnect the fuel hose from the fuel pump.
10. Disconnect the fuel hose at the engine purge port or at the evaporative
control system check valve; refer to
11. Disconnect the machine wire harness from the left side of the engine:
• Violet wire at the engine magneto lead
CAUTION
7–22).
Figure 16
2. Choke control cable clamp
Evaporative Control System (page
Page 4–16
Removing
Air Cleaner Assembly
4–13).
Sand Pro ® 3040 and 5040
20251SL Rev A