Sony BCU-100 Maintenance Manual page 33

The diagnostic name is defined in advance, so the executed diagnosis can be identified by the log file
name.
n
The Tera Term Log dialog stays displayed on the task bar while the diagnostic function is being executed.
However, do not open this dialog and press the buttons inside.
Otherwise, the log cannot be obtained and the ERR judgment cannot be performed.
The log file name is determined as follows.
Log file name list
Diag name
Fan Check
Firmware Memory Check
Main Device Check
HDD Read Check
Basic All Check
USB Storage Check
MEM-122/126 Board Check
Resolution Check
EDID Check
BE-VIF I/F Check
FAN_1 Reset
FAN_2 Reset
FAN_3 Reset
FAN_4 Reset
FAN_5 Reset
All FAN Check
Read Error Log
Delete Error Log
Before Board Exchange
After Board Exchange
6. Judgment of the execution result of the diagnostic function
. The execution result of the diagnostic function is displayed in a dialog.
[RESULT] diagnosis item: = = Judgment = =
. The judgment is also saved in a log file.
. When the judgment is NG, the error code number is displayed. Check the details in the error code list.
BCU-100 MM
Log file format
fan_check_YYYYMMDD_Serial number.log
firmware_memory_check_YYYYMMDD_Serial number.log
main_device_check_YYYYMMDD_Serial number.log
hdd_read_check_YYYYMMDD_Serial number.log
basic_check_all_YYYYMMDD_Serial number.log
usb_storage_check_YYYYMMDD_Serial number.log
mem122/126_memory_check_YYYYMMDD_Serial number.log
vga_check_YYYYMMDD_Serial number.log
xga_check_YYYYMMDD_Serial number.log
wxga_check_YYYYMMDD_Serial number.log
wuxga_check_YYYYMMDD_Serial number.log
edid_read_YYYYMMDD_Serial number.log
i2c_check_YYYYMMDD_Serial number.log
fan1_reset_YYYYMMDD_Serial number.log
fan2_reset_YYYYMMDD_Serial number.log
fan3_reset_YYYYMMDD_Serial number.log
fan4_reset_YYYYMMDD_Serial number.log
fan5_reset_YYYYMMDD_Serial number.log
fan_reset_all_YYYYMMDD_Serial number.log
read_error_log_YYYYMMDD_Serial number.log
delete_error_log_YYYYMMDD_Serial number.log
before_be28_replacement_YYYYMMDD_Serial number.log
after_be28_replacement_YYYYMMDD_Serial number.log
1-25 (E)