Huawei SmartAX MA5600T Hardware Description page 937

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Hardware Description
DIP Switch
S6-8
Table 6-7
Table 6-7 Mapping of S5 and ports for sensors
DIP Switch
S5-1
S5-2
S5-3
S5-4
S6-1 to S6-5 are used to set the subnode addresses of the ESCA board. For details, see
6-8.
Table 6-8 Mapping of S6-1 to S6-5 and the subnode address
DIP Switch Settings (5, 4, 3,
2, 1)
00000
00001
00010
00011
Issue 24 (2018-07-30)
Indication
S6-8 is used to set the baud
rate of the communication
between the ESCA board
and the control board.
l ON: The baud rate of the
l OFF: The baud rate of
shows the mapping of S5 and ports for sensors.
OFF
The external sensor of JTA1 is of the
voltage type.
The external sensor of JTA2 is of the
voltage type.
The external sensor of JTA3 is of the
voltage type.
The external sensor of JTA4 is of the
voltage type.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
communication between
the ESCA board and the
control board is 19200
bit/s.
the communication
between the ESCA board
and the control board is
9600 bit/s.
Addres DIP Switch Settings (5, 4, 3,
s Value 2, 1)
0 10000
1 10001
2 10010
3 10011
6 Electromechanical Device
Default Settings
ON
ON
The external sensor of
JTA1 is of the current type.
The external sensor of
JTA2 is of the current type.
The external sensor of
JTA3 is of the current type.
The external sensor of
JTA4 is of the current type.
Table
Addres
s Value
16
17
18
19
917