Because you are replacing an existing node from a cluster, you do not require any
additional licenses, since the cluster will retain the licenses used from the existing node
and the Cluster MAC-ID does not change, even if you are replacing node 1.
Capturing information from the existing node
To start, capture and record information from the existing node.
Procedure
1. Use the table below to record the information of the node to be replaced. This table
will help you later during the node replacement process, by providing all the needed
information.
Node Number
Softwear Version
ETH0 Node IP Address
ETH0 Subnet Mask
ETH1 IP Address (if
applicable)
WWN-Port 1
WWN-Port 2
WWN-Port 3
WWN-Port 4
2. How is the current node connected to the storage?
Direct Connected
3. Is the storage using Host Group Security?
No
Preparing the new node
Prepare the new node prior to installation.
Hitachi NAS Platform and Hitachi Unified Storage Series 4000 Hardware Reference
Information of the node to be replaced
Appendix A: Server replacement procedures
Capturing information from the existing node
SAN Connected
Yes
110