Bosch RADION B810 Installation Manual page 34

34 en | RADION receiver SD
On (Normal)
Continuous slow flash: 1 sec
On, 1 sec Off
Turns Off momentarily
Flash 3 times
Communication error state:
The receiver enters a communication error state when, during
power up, it does not establish a link with the control panel, or
has been in an idle state for more than 30 sec without
communication. Another cause for a communication error state
is an invalid address switch setting (0, or 9).
LED condition
3-pulse flash: A 3-pulse signal,
followed by a short delay at
the end of the 3
(Communication error)
2020.05 | 13 | F.01U.261.834
rd
pulse
RADION receiver SD
Indicates the receiver is
functioning normally.
Indicates the receiver is being
programmed with the zone
and transmitter ID's from the
compatible control panel.
Indicates the receiver
obtained a valid transmission
from a RADION transmitter.
Indicates the receiver has
obtained a new device ID
while in "Learn Mode."
State description
Indicates the receiver has
experienced a communication
failure. This error could be a
result of either:
– A communication failure
between the control
panel and receiver, or
– An invalid address switch
setting
Bosch Security Systems B.V.