24
en | RADION receiver SD
Failure conditions
The following conditions describe the state of the keyfob when
it no longer arms/disarms the security system:
–
–
–
Synchronizing the keyfob with the receiver
Perform the following steps to reset the receiver and restore
arming/disarming functionality for the keyfob.
Resetting the receiver:
1.
2.
3.
4.
5.
6.
7.
8.
3.4.2
Base installation
Some consideration and planning are required when locating a
position to install onto the desired surface. The base must be
installed to provide plenty of accessible space to insert a flat-
headed screwdriver, and remove the receiver cover for
maintenance and troubleshooting.
2020.05 | 13 | F.01U.261.834
The keyfob is correctly programmed in the control panel,
and
The receiver LED flashes when the keyfob is activated, but
The expected action (arm/disarm) does not occur at the
control panel.
Power off the receiver (or remove the receiver from its
base).
Set the receiver address switch to 9.
Power on the receiver (or re-attach the receiver to its
base).
LED indicates the firmware version. The LED turns on
steady for a short time to reset the receiver, and then turns
off. Replace the receiver if the LED continues to flash.
Power off the receiver (or remove the receiver from its
base).
Set the receiver address switch back to the original address
setting.
Power on the receiver (or re-attach the receiver to its
base).
Your system is ready for normal operation.
RADION receiver SD
Bosch Security Systems B.V.