Enroll Point Rf Id For Wireless Points (Auto-Learn Mode) - Bosch RADION B810 Installation Manual

RADION receiver SD
2.
3.
4.
3.4.5 Enroll point RF ID for wireless points (Auto-learn
mode)
A second option exists whereby new devices are discovered on
the system. This option is referred to as the "Auto Learn Mode"
option. Auto Learn Mode is the process through which the
control panel identifies and enrolls new device RF ID's that
appear within the system. This is achieved by the following:
–
–
Notice!
The Auto Learn mode option is not recommended as the
preferred method of entering in the RF ID's due to the potential
of the RADION system picking up the first available RF ID it
detects. For optimal results, manually enter in the RF ID's
through the supported keypad, or via RPS.
Enrolling a wireless point RF ID
Using a supported keypad, enroll the RF ID through the Wireless
menu option. Use the Wireless menu to add, replace, remove,
and diagnose points and repeaters.
Perform the following to enroll in the RF ID:
1.
Bosch Security Systems B.V.
Select RF Repeaters.
Select Signal and choose the repeater. Various sub-
categories display including:
– Signal Strength
– Level
– Margin
Exit the menu.
Keyfobs - when the keyfob buttons are pressed, then
released.
Motion detectors - when the battery is inserted, or if
coverage pattern is disturbed by someone walking through
the coverage pattern field.
From the keypad, access the Wireless Menu, and select the
Points menu option. If adding a repeater, select the
Repeater menu option.
RADION receiver SD | en
2020.05 | 13 | F.01U.261.834
29