Table of Contents
Advertisement
SOURCE OFFSET (BKS-R1617A/R3219A)
0 is normally used. It is possible to monitor with the
offset amount added to the source number to monitor
when the monitor is on using the source offset.
Imagine you want to monitor source for HD using the standard
signal. HD signal needs to be down converted to monitor
signal from HD as a standard signal. You will need to switch
to a signal with certain offset to use the converted signal as a
monitor signal. Source offset is valid for these situations.
n
This setting is also valid when this panel is used as a
dedicated remote control panel for the virtual monitor
(Ver. 1.10 or higher).
This setting is reflected when monitoring the destination.
Setting Method
Input the number of offset after pressing the [Enter],
and confirm with [Enter].
0 =
Get same source as destination to monitor.
1 to 1023 = Get source with specified offset during
monitor.
Conventional monitor system
Conventional monitor method has divided and physically
returned the output to be monitored to the input.
Monitor function has realized this using software.
Example of the source offset system
HD signal
Down-conversion
HD system
Standard system
Source offset
SOURCE OFFSET setting value
BKS-R3219A/R1617A I&SSM
MONITOR DESTINATION
setting value
Monitor display panel
HD
D1
D1signal
Monitor display panel
CONTROL LEVELS (BKS-R1617A/R3219A)
Press [Enter] at the position of the level (third "_" for
level 3) if you would like to change the specific level
from the remote control unit.
Far left is level 1 and far right is level 16.
Just turn on the level you would like to use if you would
like to use it as a panel dedicated for audio level or
something.
Setting Method
Press [Enter] at the position of the level (third "_" for
level 3) if you would like to use the specific level from
the remote control unit. Turned on level will display its
level with the number. It toggles between selected and
not selected every time [Enter] is pressed.
Level set here is independent from LEVEL MODE
and could be set arbitrary.
_ =
Do not switch that level
Other than _ = Switch that level
n
Normally use with all "_". It will switch to the level set at
the primary station for each destination in this status.
3-21
Advertisement
Table of Contents
