Table of Contents
Advertisement
Figure 98
1. Jumper-cable post
(negative)
7.
Connect the positive (+) jumper cable to the
jump post
(Figure
8.
Connect the negative (-) jumper cable to a
ground point, such as an unpainted bolt or
chassis member
9.
Start the engine; refer to
Off the Engine (page
Important:
If the engine starts and then
stops, do not operate the starter motor until
the starter motor stops turning. Do not
operate the starter motor for more than 30
seconds at a time. Wait 30 seconds before
operating the starter motor to cool the motor
and to build up the charge in the battery.
10.
When the engine starts, have the other person
disconnect the negative (-) jumper cable from
the frame and then disconnect the positive (+)
jumper cable
(Figure
2. Jumper-cable post
(positive)
98).
(Figure
98).
Starting and Shutting
47).
98).
Drive System
Maintenance
Checking the Planetary
Drive Oil Level Planetary
Drive
Service Interval: Every 50 hours—Check the
Oil specification: SAE 85W-140 API classification
g234645
level GL4
Planetary drive oil capacity: approximately 1.4 L
(1.5 US qt)
Toro Premium Gear Oil is available from an Authorized
Service Dealer. See the Parts Catalog for part
numbers.
1.
Move the machine to a level surface, shut off
the engine, and remove the key.
2.
Clean the area around the oil-level plug with a
cleaning solvent
1. Oil-level plug
3.
Rotate the planetary drive until the oil level and
the oil-drain plugs are vertical to the ground (at
the 6 o'clock position) as shown in
4.
Remove the oil-level plug
Note:
The oil level is correct when it is up to the
bottom of the oil-level plug hole.
5.
If the oil is below the bottom of the hole, add the
specified oil until the oil is level with the bottom
of the hole.
6.
Install and tighten the oil-level plug.
81
planetary-drive oil level (Also, check
if external leakage is observed).
(Figure
99).
Figure 99
2. Oil-drain plug (6 o'clock
position)
(Figure
99).
g021828
Figure
99.
Advertisement
Table of Contents
