Table of Contents
Advertisement
Figure 94
1. Jumper-cable clamp
(positive)
2. Jump post
3. Cover
7. Connect the positive (+) jumper cable to the jump post
(Figure
94).
8. Connect the negative (-) jumper cable to a ground
point, such as an unpainted bolt or chassis member
(Figure
94).
9. Start the engine; refer to
Engine (page
43).
Important: If the engine starts and then stops,
do not operate the starter motor until the starter
motor stops turning. Do not operate the starter
motor for more than 30 seconds at one time. Wait
30 seconds before operating the starter motor to
cool the motor and to build up the charge in the
battery.
10. When the engine starts, have the other person
disconnect the negative (-) jumper cable from the
frame and then disconnect the positive (+) jumper
cable
(Figure
94).
4. Ground point (unpainted
bolt)
5. Jumper-cable clamp
(negative)
Starting/Stopping the
Drive System
Maintenance
Checking the Oil Level for the
Planetary Drive
Service Interval: Every 50 hours—Check the planetary-drive
oil level (Also, check if external leakage
is observed).
Oil specification: SAE 85W-140 API classification level GL4
Planetary drive oil capacity: approximately 1.4 L (1.5 US qt)
Toro Premium Gear Oil is available from an Authorized Toro
Service Dealer. See the parts catalog for part numbers.
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Clean the area around the oil-level plug with a cleaning
solvent
(Figure
95).
1. Oil-level plug
3. Rotate the planetary drive until the oil level and the
oil-drain plugs are vertical to the ground (at the 6
o'clock position) as shown in
4. Remove the oil-level plug
Note: The oil level is correct when it is up to the
bottom of the oil-level plug hole.
5. If the oil is below the bottom of the hole, add the
specified oil until the oil is level with the bottom of
the hole.
6. Install and tighten the oil-level plug.
7. Repeat steps
1
through
oil level on the other side of the machine.
74
Figure 95
2. Oil-drain plug (6 o'clock
position)
Figure
95.
(Figure
95).
6
to check the planetary-drive
Advertisement
Table of Contents
