12. Extrude the guide pins in the direction of the arrow 1 slowly, then hang the grooves of the guide
pins on the frame holes.
13. Remove the cell assembly from the front side of panel in the direction of the arrow 2.
14. Remove the guide pins.
t
Place the cell assembly on the lower tray. (Refer to "When placing the cell assembly on the table" in
this section.)
Frame hole of
display unit
Front side of panel
4-32 (E)
Groove
Guide pin
1
1
Guide pins
2
Cell assembly
Front side of panel
Cell assembly
Guide pins
ZRD-1/ZRD-2