Installation; Example Can Bus System; Installation - Before Starting - GE BAKER HUGHES DPS 5000 Series Instruction Manual

2. Installation

This section details installation of the pressure transducer, when complete the pressure
transducer can be prepared for operation (refer to Chapter 3., "Operation," on page 5).

2.1 Example CAN bus System

CAN_X
This shows the pressure transducers in an example CAN bus system and must have these
items:
• A CAN bus with an applicable input/output device for the signal lines (applicable to
the electrical connection on the pressure transducer).
• Power supply: 5 V dc to 30 V dc.
• All applicable tools to connect the pressure and electrical connections, as detailed in
the applicable system installation manual.
2.2 Installation – Before Starting
Make sure to use the correct pressure transducer (refer to Chapter 1., "Introduction," on
page 1).
Read all relevant instructions and procedures in the applicable system installation manual.
Read the following installation procedures before installing the pressure transducer.
© 2018 Baker Hughes, a GE company – All rights reserved.
Figure 2-1: An Example CAN bus System
Example CAN bus System
CAN_GND
CAN_H
CAN_L
CANopen
software
package
DPS 5000 Series Instruction Manual-English | 3