Sensor Position; Position Of Vehicle On Measurement Bay - Bosch FWA 4630 Original Instructions Manual

en | 34 | FWA 4630 | Operation
4 .3

Sensor position

Fig. 9: Sensor (on left/right) of vehicle
i
The sensors have fixed positions (left/right) on
the vehicle as shown by the pictogram. Details
can be found in the "Commissioning" document
1690706006
i
Make sure the vehicle is driven centrally and straight
onto the measurement bay.
|
1 690 706 005 2011-05-11
4 .4 Position of vehicle on measurement
bay
Fig. 10:

Position of vehicle on measurement bay

1 Rolling distance 250 mm
2 Safety clearance 200 mm
1. Pay attention to the minimum distance between the
center of the turntable and the center of the sensor,
950 mm (X). Position the turntable accordingly on
the measurement bay.
Wheelbase [mm] X [mm]
1900 – 2400 950
2400 – 4300 1450 – 1750
2. Enter the spacing of the two sensors under
<Maintenance><Options><System settings>
<Distance><Reference System>.
i
For lifting platforms with adjustable runways, make
sure the correct spacing value has always been
stored in the program.
Fig. 11: Sensor spacing measurement points
Robert Bosch GmbH