Stand-Alone System Installation; Rack System Installation; A-Series Rack Installation - HP 3000 Series Handbook

For HP Internal Use Only
Stand-alone System Installation
1. Unpack the system.
2. Inspect for damage.
3. Move the equipment to where it will be used.
4. Install any additional I/0 PCAs.
5. Install and configure any external peripherals.
Note
"
If no SCSI peripherals are connected to the Multifunction I/0 PCA, install
SCSI terminator, P /N 1252-3932, on the
SCSI
connector.
6. Cable everything to the system. Refer to the system Installation and Configuration
manual for specific cabling instructions.
7. Power up the external peripherals.
8. Power up the system.
9. At the ISL prompt, verify the I/0 hardware configuration with MAPPER in the Offline
Diagnostic Environment (ODE).
10. Boot the operating system.
11. Customize the system.
Rack System Installation
A-Series Rack Installation
1. Unpack the system.
2. Inspect for damage.
3. Move the system to where it will be used.
4. Cable the LAN, if necessary.
5. Connect power to the rack.
6. Power up the system.
7. At the ISL prompt, verify the I/0 hardware configuration with MAPPER in the Offline
Diagnostic Environment (ODE).
8. Boot the operating system.
9. Customize the system.
3-2 Installation and Preventive Maintenance