Huawei NetCol8000-C070 User Manual page 166

NetCol8000-C(070, 130, 190) In-room Chilled Water
Smart Cooling Product
User Manual
Step 3 (For the upflow units) Remove the sheet metal fastener using a Phillips
screwdriver, and cut off the cable tie on the water inlet pipe for the wet film
humidifier.
Step 4 (For the downflow units) Rotate the sheet metal fastener and remove it manually.
Step 5 (For the upflow units) Extract the wet film humidifier, then remove the hose
clamp and the water inlet pipe for the wet film humidifier.
Step 6 (For the single-door of downflow units) Pull out the wet film humidifier along the
guide rails, then remove the hose clamp and the water inlet pipe for the wet film
humidifier, as shown in
Step 7 (For the double-door or triple-door of downflow units) Remove the hose clamp
and the water inlet pipe for the wet film humidifier, then extract the wet film
humidifier.
Figure 6-3 Removing an upflow wet film humidifier
Figure 6-4 Removing a downflow wet film humidifier (NetCol8000-C070D)
Issue 02 (2020-08-30)
Figure 6-4.
Copyright © Huawei Technologies Co., Ltd.
6 System Operation and Maintenance
158