Yamaha AN1x Owner's Manual page 74

Convenient Parameter Control
You can use the Control Matrix sets to assign a single
controller to control more than one parameter, or multiple
controllers to control the same parameter.
[Ex. 1]
One controller to control more than one parameter
Set Param Source
1 VCF Cutoff A.MW
2 Resonance A.MW
[Ex. 2]
Multiple controllers to control the same parameter
Set Param Source
1 VCF Cutoff A.MW
2 VCF Cutoff A.RbX
Procedure For Using The Control Matrix
1. Select the Set No (1-16).
2. Select the Parameter you want to control.
3. Select the Source (controller) for the parameter
control.
4. Set the Depth value.
5. Repeat steps 1-4 to assign additional controller
sets.
For more information about the Control Matrix, the separate Data List book.
Depth
+25
+30
Depth
+20
-10
74
Set No
(Set Number)
The Set Number parameter lets you select Pitch Bend
Pitch Up and Down, the number of the Set (1-16), and
Common (1 and 2) parameter assignments.
Settings:
PB Pitch : Selects the Pitch Bend Up parameter for setting
the range over which the pitch bends up (above a value of
64) when rolling the Pitch Bend wheel between center and
maximum forward position (for the selected Scene).
PB Pitch : Selects the Pitch Bend Down parameter for
setting the range over which the pitch bends down (below a
value of 64) when rolling the Pitch Bend wheel between
center and maximum back position (for the selected Scene).
Set 1 ~ 16: Selects the Set Number to which you want to
assign Parameter, Source and Depth settings (for the selected
Scene).
Comn 1 ~ 2 (Common Set 1 ~ 2): Selects the Common
Set number to which you want to assign Parameter (Off,
Common Volume, Common Pan, Variation Parameter, Delay
Return, Reverb Return), Source and Depth settings (applied to
both Scenes).
Parameter
The Parameter setting determines which parameter is
assigned to the Set Number (1-16) or Common Set (1-
2). When Set No is set to "PB " or "PB " you don't
need to select the Parameter because these are the
parameters for Pitch Bend.
Settings:
For a list of Control Matrix parameters, see the separate Data
List book.