Fm Depth - Yamaha AN1x Owner's Manual

Sync Pitch Src
The Sync Pitch Source setting determines the source
which applies the modulation over time to the slave
oscillator.
Settings: fixed, PEG, FEG, LFO1, LFO2
When set to "fixed", there is no change in modulation over time.
Sync Pmod Sw
Modulation Switch)
The Sync Pitch Modulation Switch setting determines
which oscillator (master, slave, or both) is modulated
by the LFO1. Depth rate is determined by the VC01
Pmod Depth setting (see page 63).
Settings: mastr, slave, both
Pitch Modulation cannot be controlled by LFO2.

FM Depth

The FM Depth setting determines the amount of
modulation created by FM Source 1 (see next
parameter). Turning the knob to the right increases the
Depth.
Settings: -64 ~ 0 ~ +63
This is a different type of parameter than that used in the Yamaha DX-series FM
synthesizers. Too deep of a setting will change the pitch of the voice. Adjust the
pitch using the VCO1 Pitch and Fine parameters (see pages 61, 62).
(Sync Pitch Source)
(Sync Pitch
60
FM Src1
(FM Source 1)
The FM Source 1 setting determines the modulation
source which controls the FM Depth (see previous
parameter).
Settings: fixed, PEG, FEG, LFO1, LFO2
When set to "fixed", there is no change in modulation over time.
FM Src2
(FM Source 2)
The FM Source 2 setting determines the source wave
which modulates the VCO1 wave.
Settings: VCO2, VCO1, VCO1s (sub oscillator), PEG, FEG,
LFO1, LFO2