Checking The Warning Labels On The Main Unit; Warning Mark On The Model 2000; Safety Label - Toshiba V Series User Manual

1. Checking the Warning Labels on the Main Unit

Make sure warning markings are attached on the model 2000.
If any of them are missing or the wording is illegible, contact Toshiba's Service Department.

[Warning Mark on the model 2000]

This is the warning mark for dangerous location. It is attached to the equipment at positions where
!
there is a risk of electric shock and at positions where there is a risk of damage to the equipment
through incorrect wiring.
Take the following precautions where this mark is found
(1) Keep hands away from terminals, especially the input terminal of the power supply while power is
on, to avoid the risk of electric shock.
(2) Turn off power before installing or removing modules, terminal blocks, or wires.
(3) Applying excess power voltage to the model 2000 can cause failure or malfunction. Apply power of
the specified ratings described in this manual.
(4) Turn off the power of the tool (a personal computer, etc.) before connecting the connector to the tool
port. Afterwards, turn on power.
Avoid short-circuiting between the tool connector pins with the cover, etc.

[Safety Label]

Supplementary
Marks printed at pages in this manual should always be read carefully.
Be sure to read them in handling your model 2000.
ii
The safety label as shown on the left both in Japanese and English
is attached to the power supply terminal of the model 2000. (exept
the 24Vdc input power supply module)
Remove the mount paper before wiring
Peel off either of the Japanese and English labels from the mount
paper and stick it to the model 2000 or near the power terminal
where it can be readily seen.
In the event the seal is damaged, contact the dealer.
model 2000 Sequence Controller S2 User's Manual -Basic Hardware-