ABB ACH580 Series Installation, Operation And Maintenance Manual page 66

66
Code
(hex)
64B1
64B2
64E1
64B1
6581
6591
ACH580 Ultra-Low Harmonic Drives Installation
ACH580 Ultra-Low Harmonic Drives Installation, Operation and Maintenance Manual
Fault / Aux. code
001C
001D
001E
0023
0024
Other
Internal SSW fault
User set fault
Kernel overload
Fault reset
Parameter system
Backup/Restore timeout
Cause
A non-existing Edit the program to correct the
parameter or block is parameter reference, or to use an
used in the program. existing block.
Parameter type invalid Edit the program to correct the
for selected pin. parameter reference.
Output to parameter Check the parameter reference in the
failed because the program.
parameter was
Check for other sources affecting the
write-protected.
target parameter.
Program file Adapt the program to current block
incompatible with library and firmware version.
current firmware
version.
– Contact your local ABB
representative, quoting the auxiliary
code.
Internal fault. Reboot the control unit (using
parameter 96.08 Control board boot)
or by cycling power. If the problem
persists, contact your local ABB
representative.
Loading of user Ensure that a valid user parameter set
parameter set failed exists. Reload if uncertain.
because
requested set does not
exist
set is not compatible
with control program
drive was switched off
during loading.
Operating system error. Reboot the control unit (using
parameter 96.08 Control board boot)
or by cycling power. If the problem
persists, contact your local ABB
representative.
A fault has been reset. Informative fault.
The cause of the fault
no longer exists and
the fault reset has been
requested and
completed.
Parameter load or save Try forcing a save using parameter
failed. 96.07 Parameter save manually.
Retry.
During backup creating Check panel or PC-tool
or restoring operation a communication and if it is still in
panel or PC-tool has backup or restore state.
failed to communicate
with the drive as part
this operation.
What to do