Hydran* 201i Instruction Manual
6
BEFORE INSTALLATION
6.1
General Warnings
1. Do not separate the Hydran 201Ti Intelligent Transmitters from their respective
Hydran 201 sensor. The H201Ti is set at the factory for a specific H201 sensor. To
verify whether the two components are paired correctly, consult the serial
numbers indicated on the shipping box and/or the Test Certificate and Data
Sheet. The sensor's serial number is located below the connector (see Figure 3-3);
while the H201Ti's serial number is located at the back of the heating plate (see
Figure 6-1 below).
2. Do not remove the protective plastic caps from the sensor and/or the brass
adaptor's threaded extremity until ready to install on the transformer valve.
These caps protect the adaptor threads (see Figure 6-1 above) and the sensor
membrane from debris and sharp objects. If the sensor is dismounted, place
immediately the supplied cap onto the sensor's threads.
MA-033
Rev. 14.0, 12-Nov-18
Figure 6-1: H201Ti's Serial Number and Protective Cap
Page 79