Table of Contents
Advertisement
Appendix
D
Setting Up Network Communications
This is the standard and most straight forward method of setting the network
parameters on the camera as it does not require a serial connection.
Select DHCP ("Obtain an IP address automatically") or Static IP ("Use the
2.
following address") and fill in a logical address and network mask, as shown
in Figure D–1. Also, see Table D–1.
FIGURE D–1.
When you are done, click OK. The camera will be rebooted automatically
3.
for the changes to take effect.
Note: All the Network parameters of the camera are stored in Non-Volatile
memory and can also be modified from the Bootloader (a low-level diagnostics
program) that can be invoked using HyperTerminal and a Serial connection. This
D-2
Network Overview & Network Settings
SIMATIC HawkEye™ 1600T Smart Camera Guide
Rev. 1E, Nov 2007
Advertisement
Table of Contents
