Table of Contents
Advertisement
BODY AND TRIM
Figure 4-10 Bed Latch Plates
SEAT BACK SUPPORT BRACKET REMOVAL
1. Remove bolts from seat back and support brackets and remove seat back.
2. Remove seat back support bolts and bed support weldment with bed bumpers from seat back supports
(Figure 4-11, Page 4-9).
3. Remove seat back support bolts from body and remove from vehicle (Figure 4-12, Page 4-9).
Figure 4-11 Seat Weldment Support
SEAT BACK SUPPORT BRACKET INSTALLATION
1. Align passenger and driver side seat back support brackets with holes in body (Figure 4-12, Page 4-9).
See following NOTE.
NOTE: Striker plates should be to the outside of each bracket.
2. Install bracket bolts to body and tighten hardware to 14.5 ft-lb (19.6 N·m).
3. Position bed support with bumpers onto seat back supports and frame (Figure 4-11, Page 4-9).
4. Install bracket and bed support bolts to frame and tighten to 100 in-lb (11.3 N·m).
2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
Seat Back Support Brackets
Figure 4-12 Seat Back Body Support
4
Page 4-9
Advertisement
Table of Contents
