Cargo Bed; Cargo Bed Removal; Cargo Bed Installation; Bed Latch Assembly - Husqvarna HUV4210 2005 Series Maintenance Service Manual

4
BODY AND TRIM

CARGO BED

See General Warning, Section 1, Page 1-1.

CARGO BED REMOVAL

NOTE: This procedure requires two people.
1. Raise bed and remove the rue rings on the end of each clevis pin.
2. Remove hinge clevis pins and remove bed from vehicle. See following CAUTION and WARNING.
CAUT ION
• Support bed as pins are removed.
• Keep bed hinges as close to alignment as possible to avoid binding the pins during removal.
ý
WARNING
• Keep hands and arms from between the bed and vehicle frame and do not allow the bed to
drop.

CARGO BED INSTALLATION

NOTE: This procedure requires two people.
Lubricate the hinge clevis pins with light motor oil prior to assembly.
1. Position the bed to align with the hinge locations.
2. Install hinge clevis pins and washers, with the head of the pin to the inside portion of the bed. See fol-
lowing CAUTION and WARNING.
CAUT ION
• Keep bed hinges as close to alignment as possible to avoid binding the pins during removal.
ý
WARNING
• Keep hands and arms from between the bed and vehicle frame and do not allow the bed to
drop.
3. Install rue rings and washers on the end of the hinge clevis pins.
4. Lower the bed onto the bed latch plates. Adjust the latch plates if necessary.

BED LATCH ASSEMBLY

1. Remove the two latch link support bolts and remove latch rod and catch plate assembly from bed
(Figure 4-4, Page 4-7).
2. Remove and replace any damaged or broken latch springs.
Page 4-6 2005-2006 HUV4210-G, 4210-E, 4210-GXP, 4210-EXP Maintenance and Service Manual
Cargo Bed