Commissioning A Camera (Smart Eth Gateway Networking Scenario); Commissioning Ipc6325 Cameras - Huawei ECC800-Pro User Manual

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
LAN Switch Networking Scenario
If there are multiple VCNs for multiple smart modules, you are advised to evenly
distribute the cameras to each VCN.
Figure 6-9 Camera + VCN connecting to the LAN switch
6.5.3 Commissioning a Camera (Smart ETH Gateway
Networking Scenario)

6.5.3.1 Commissioning IPC6325 Cameras

Prerequisites
●
●
●
Context
●
●
●
●
Issue 02 (2020-09-07)
If multiple cameras are accessed, retain the connection of one camera and
disconnect connections from other cameras. After commissioning the
connected camera, commission other cameras in the same way.
The camera has connected to the smart ETH gateway and the smart ETH
gateway communicates properly with the ECC800-Pro.
The camera software version is later than V500R019C30.
Before commissioning the IPC6325 camera, set the IP address for the IPC6325
camera based on customer requirements.
Configure the camera or VCN internal IP address and the IP address of the
LAN port on the ECC800-Pro in the same network segment.
Configure the camera or VCN internal IP address and the IP address of the
WAN_1 port on the ECC800-Pro in the same network.
Set the internal and external IP addresses as planned by the customer. The
following IP addresses are for reference only.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
144