Huawei ECC800-Pro User Manual page 250

ECC800 Data Center Controller
User Manual (for ECC800-Pro)
Step 2 Choose System Settings > NMS Application > Transparent Transmission
Channel.
Step 3 Set COM2(Port:3212) to Enable and click Submit.
Figure 6-85 Transparent transmission channel
Table 6-54 Mapping between ECC800-Pro ports and port numbers
COM Port
Port Number
If a device is connected to a COM port on the UIM20A expansion module, the port
number is displayed on the WebUI after transparent transmission is enabled for
the COM port and the configuration is saved. For example, the port number of
COM1 on UIM1 is 3215 in
●
●
Step 4 Log in to the NetEco WebUI as an administrator.
Step 5 Choose System > Configuration > Data Center Planning. The Data Center
Planning window is displayed.
Step 6 Select the management domain to add a device. The management domain can be
a micro-module, container, cabinet or computer room.
Issue 02 (2020-09-07)
COM1
3211
NO TE
● An ECC800-Pro can connect to a maximum of four UIM20A expansion modules with the
transparent transmission function.
● A UIM20A expansion module provides a maximum of eight COM ports with the
transparent transmission function.
If the port is set for the first time, you are prompted to set an authentication
password. On the Set Authentication Password tab page, set
Authentication password and Confirm authentication password and click
Submit.
NO TE
Enable security Authentication is set to Enable by default. If so, an authentication
password must be set. If Enable security Authentication is set to Disable, there is no
need to set an authentication password but this is risky.
If the port has been used, you will be prompted that the transparent
transmission function cannot be enabled and you need to select an idle port.
Copyright © Huawei Technologies Co., Ltd.
COM2
3212
Figure 6-85.
6 Feature Description
COM3 COM4
3213 3214
239