The Configure Window - Canon Oce BLM550+ Operation Manual

The CONFIGURE Window

The CONFIGURE Window
Introduction
The CONFIGURE
Some functions and buttons are only available at certain access levels, see 'ACCESS LEVEL'
Button overview on page
CONFIGURE Window Buttons
Button overview
Button
MACHINE OP‐
TIONS
- MEASURE-
MENT
- STITCH SEN-
SOR
- PRESET PAPER
SIZES
- PBS INSTALLED Touch BOOK STACKER to switch off
SHUTTLE
-TAMPER DELAY
- TAMPER TIME
FORM SETUP
38 Chapter 4 - The User Interface
window lets you make changes to the configuration of the machine.
39.
Information
Touch MACHINE OPTIONS to view
the general machine setup. Some of
the settings can be changed, depend-
ing on the current access level.
Select 'mm' or 'inch' as the unit of
measurement.
There is a sensor that checks for
stitches. Touch STITCH SENSOR to
turn the stitch sensor on or off. The
default setting is ON.
The preset paper sizes can be either
ISO A sizes or US paper sizes. To se-
lect which preset paper sizes are
available, touch the relevant button.
communication to the Book Stacker.
Only if the Book Stacker is discon-
nected.
Touch SHUTTLE to make adjust-
ments to the tamper.
This button is used by the service en-
gineer.
TAMPER TIME adjusts the time that
the tamper touches the set.
An increase in TAMPER TIME causes
a decrease in the production rate for
thin books.
This button is used by the service en-
gineer.
Operator Supervisor
Hidden Active
Hidden Active
Hidden Active
Hidden Active
Hidden Active
Hidden Active
Hidden Visible
Hidden Active
Visible Visible